Aastra 600d for Aastra 800 and OpenCom 100 User Guide EN Instrukcja Użytkownika Pobierz pdf (Strona 113)

The Device Menu

111

Device: You can select the combination of signal generators with which the

call will be signalled. Press the

Edit

softkey to switch a signal generator

on/off.

Ringer: Signalling via loudspeaker.

Vibra call (not on the Aastra 610d): Signalled via vibrator.

Headset: Signalled on the headset if this is connected to the mobile

unit.

Note: If you switch off all signal generators, a call is only signalled opti-

cally on the display.

Volume: Displays the currently set ringer volume. For changing the volume,

use the and navigation keys or enter a number (1 … 7) (Increasing

or level 1…7).

Noise detection: When this feature is switched on, ringer volume is automati-

cally increased when ambient noises are loud. If you wish to use this

feature, you should not set the ringer setting volume at Increasing.

Attention tones: Select whether the respective attention tones are switched on or

off.

Key click: Acoustic confirmation of key press.

Confirm tones: Confirms successful/failed settings.

End of menu: Info tone when the end of a list/menu is reached.

Battery warning: Info tone when the battery has only low capacity remaining.

There are just a few minutes remaining before the connection is discon-

nected.

Coverage warning: Info tones when the radio connection threatens to break

off.

Alarm tone (Aastra 630d only): alarm tone which sounds during the pre-alarm

(triggered by alarm sensor). This setting is also in the Alarm sensor

menu (see page 133).

Loud environment: If this setting is activated, the mobile unit attempts to improve

voice transmission in a loud environment (does not apply when operating a

Bluetooth headset or in handsfree mode).

1 2 ... 108 109 110 111 112 113 114 115 116 117 118 ... 163 164

Brak uwag

Aastra 600d for Aastra 800 and OpenCom 100 User Guide EN Instrukcja Użytkownika Strona 113