
Installation and Setup
5 41-001389-00 Rev 02 – 04.2012
Installation and Setup
The following procedure provides instructions for setting up the BluStar 8000i terminal, and for connecting it to your net-
work.
1. Carefully remove the BluStar 8000i components from their shipping container and place them on a clean, flat, dry
surface (typically a desktop).
2. Connect one end of the handset cable to the RJ-11 connector on the end of the handset, and the other end to the RJ-
11 connector on the underside of the terminal.
Note:
You can tuck the cord into the indent at the side of the terminal.
3. Connect the Ethernet cable (provided with the BluStar) into the network LAN port marked with . Contact your
network system administrator for help with this connection.
4. Plug the other end of the Ethernet cable directly into the jack on the wall.
Komentarze do niniejszej Instrukcji